Setting up Filament

Setting up Filament

Step 1: Go to Prepare and select Change Filament and select preheat PLA.

Step 2: Fix the filament holder in the hole provided on the printer's left side and place the filament in it such that its loose end is towards the backside.

Step 3: Take the loose end of the filament and load it into the filament guider by pushing it upward such that the filament comes through the top side.

Step 4: Take one end of the PTFE tube and push it into the Filament guider, make sure to push it until it gets locked.

​

Step 5: Push the filament through the PTFE tube till it comes out from the other side.

Step 6: Once it attains the temperature Click the knob to select insert the filament Press the lever on the extruder head and push the filament into the extruder head until the filament crosses the gears and reaches the hotend.

• Related Articles

• Setting up Filament

  Setting up Filament Step 1: Go to Prepare and select Change Filament and select preheat PLA Step 2: Fix the filament holder in the hole provided on the printer's left side and place the filament in it such that its loose end is towards the backside. ...

• Setting up Filament

  Setting up Filament Step 1: Go to Prepare and select Change Filament and select preheat PLA. Step 2: Fix the filament holder in the hole provided on the printer's left side and place the filament in it such that its loose end is towards the backside. ...

• Setting up Filament

  Setting up Filament Step 1: Go to Prepare and select Change Filament and select preheat PLA Step 2: Fix the filament holder in the hole provided on the printer's left side and place the filament in it such that its loose end is towards the backside. ...

• How to Deal with Filament Feeding Issue

  How to Fix Filament issue This issue consists of the filament not extruding from the nozzle. There could be thre possible reasons for that   The filament may have got Tangled In this case the filament may have got from the spool side resulting in ...

• How to Fix Stringing

  STRINGING Normally your printer is not supposed to deposit the plastic filament in the open space while moving one point to another point. However molten plastic will often leak onto the parts where it should not. These strands of plastic are called ...