Selecting Design Step 1: Insert the SD Card in the slot. Step 2: Go to Menu select Print from SD Card and select Calibration Cube.
Setting up Filament
Setting up Filament Step 1: Go to Prepare and select Change Filament and select preheat PLA. Step 2: Fix the filament holder in the hole provided on the printer's left side and place the filament in it such that its loose end is towards the backside. ...
Navigation and Assisted Leveling
Navigation and Assisted Leveling Step 1: Press the knob, to enter the menu and select options. Step 2: while being in the menu rotate the knob to navigate around. Step 3: To start the bed leveling process, press the knob and navigate to the Home All ...
Unboxing and Primary Setup
Unboxing and Primary Setup Step 1: Place the printer on a nice flat surface. Step 2: Remove all the packing foam inside the printer and make sure it is dust-free. Step 3: Check the Accessories kit for the supplies as we mentioned. Step 4: There ...
Getting Started With HYDRA
General safety The Hydra 3D printer has the ability to reach high temperatures and make fast movements, this can cause injury if you reach inside the machine during its working condition. Listed below are the general safety instructions. Do not ...